|
cnc mill first test cut / print linux emc2 router PROTOTYPE
cnc mill first test cut / print linux emc2 router PROTOTYPE
hooked up my new cnc mill testing with a sharpie using linux cnc emc2 software gecko drive controller
From:
irishkendoll
Views:
158 [...]
|
|
HELP!!! Gecko drive G320X
HELP!!! Gecko drive G320X
I used MACH3 to send out the signal to breakout board and GECKO drive. However, the system does not work smoothly. I have checked all connections but still cannot figure out which part goes wrong. I also tried [...]
|
|
CNC Machining geckodrive Heatsink/Mount Plate
CNC Machining geckodrive Heatsink/Mount Plate
Machining a mounting plate for my geckodrive stepper drivers, used in my Sieg X3 CNC conversion.
From:
TangentAudioVideo
Views:
352
[...]
|
|
taig cnc gecko drive jewelry 4 axis milling 2 side and 4 axis rhino+ rhinocam
taig cnc gecko drive jewelry 4 axis milling 2 side and 4 axis rhino+ rhinocam
that is a perfect system for jewelry
From:
mateusz20045
Views:
234
[...]
|
|
Need help with CNC mill
Need help with CNC mill
Trying to get a CNC mill running with Mach 3 and geckodrive 201 controllers. This is a diagnostic program running from Stepperworld.com just to help me try to debug my problem. The default setting on this only [...]
|
|
g540 emc2 cnc router
g540 emc2 cnc router
This is my first test with geckodrive g540 and Linux dapper with Emc2 .Motor transmission is directly from motor to Trapezoidal Spindle (1:1).The Trapezoidal Spindle is 12x3mm and motors are 1.8° which needs 200 steps to rotate 360°.With [...]
|
|
Gecko Drive Test
Gecko Drive Test
Simple Servo motor jog test
From:
blauschuh
Views:
1112
2
ratings
Time: [...]
|
|
G320 Geckodrive test 01
G320 Geckodrive test 01
Step en Dir testprint. Toepassing: Om zonder PC, een servodrive te kunnen testen. Uitgang 1 Direction =5V of 0V Uitgang 2 Step 5V+
From:
foksp
Views:
1538
[...]
|
|
Prova cnc gecko drive e motori sanyo denky
Prova cnc gecko drive e motori sanyo denky
prima prova con l'accoppiata geckodrive e motori sanyo denky da 5 nm
From:
Garkoll
Views:
1013
[...]
|
|
G251 geckodrive Rotary Table Test
G251 geckodrive Rotary Table Test
My new G251 Gecko Drives. (Baby Geckos) I got this rotary table from a friend. It was used in conjunction with a robotic arm for educational purposes. The motor is a 75oz-in stepper motor wired for bipolar [...]
|
